What is the Difference Between Welded and Seamless Sanitary Tubing

- Oct 16, 2017 -

What is the Difference Between Welded and Seamless Sanitary Tubing?


steel pipe.jpg


Seamless Sanitary Tubing


Most seamless tubing is made using the rotary piercing and rolling method. A conditioned steel round bar is heated to a suitable forging temperature and pierced on a mill which works the bar, causing it to flow around a piercer point forming a hollow billet. This billet is then roller elongated in a succession of mills with a mandrel or plug to support the interior. Finally, the steel tube is sized by further rolling on the OD.


Welded Sanitary Tubing


The sanitary stainless steel welded tubing manufacturing process starts with rolling a steel coil at the steel mill to the proper gauge thickness. This yields a coil of flat strip. The strip is then slit to the proper width dependent upon the size tube to be made. The slit coil is then loaded onto a tube mill. From there the tube is formed by going through a series or rollers then the seam is welded in an inert atmosphere. The weld seam is then cold worked (forged) by going through a rolling operation. Finally the finished tubing is heat treated, normally through an induction annealing process.


What are the Differences and Which is Better?


There was a time when welded tubing was thought to have poorer corrosion resistance than seamless because of the weld seam. Recent improvements in the welding and forging process of welded tube have negated that argument in all but the most extreme conditions. There are some areas, like the micro electronic and semiconductor markets where that can become an issue. But in the food, beverage, and biopharmaceutical market this argument is really a non-starter.
Continually, seamless tube used to have better surface finishes, especially in smaller sizes. You can buy ¾” and ½”OD seamless tube that right off the mill has a 15RA ID surface finish. That used to be impossible with welded tube because of surface roughness around the weld bead. Improved manufacturing techniques in welded tubes have also mitigated this concern.

It’s also important to note that welding seamless tubing with a computerized orbital welder can be challenging because of inconsistencies in the weld thickness. Welded tube tends to have more uniformity in this area and can be easier to orbital weld.Then, there is the commercial area. 20Ra ID welded tubing in both 304 and 316L is readily available in sizes through 6” from a variety of manufacturers. In fact, Holland has one of the Midwest’s largest inventory of sanitary tubing. Seamless tubing is almost non-existent above 2” and is hard to find in sizes above 1”. It is also considerably more expensive.
Finally, if you are looking at using sanitary stainless steel tubing, you are also probably going to need sanitary fittings. Above ½” size, the availability of sanitary fittings made from seamless tubing is very limited. Most of the off shelf ASME BPE fittings used in the biopharmaceutical industry are made from welded tubing. So if your fittings are made that way, why go to the expense of buying seamless tube to connect to it?
Hopefully this serves as a good primer on seamless vs. welded tube. Stay tuned for new posts on all aspects of sanitary process piping and ASME BPE fittings and weld techniques in 2014 or contact Holland today for any of your sanitary process needs.


Related Products